![panasonic lumix app on pc panasonic lumix app on pc](http://wordpress-365629-1139307.cloudwaysapps.com/wp-content/uploads/2012/07/SZ5-4-595x600.jpg)
You can operate multiple cameras remotely using “LUMIX Tether”. The camera cannot be connected to “LUMIX Tether” and “LUMIX Sync” at the same time. When you use in the () menu to reset the network settings, the password to connect to the camera from “LUMIX Tether” will also be reset. Wi-Fi/Bluetooth function cannot be used while the connection is being made using a USB connection cable or LAN cable. If the camera is connected to PC using both of LAN cable and USB connection cable, the USB connection cable will be prioritized. –LAN cable (STP (Shielded Twisted Pair), category 5e or above, maximum 100 m (328 feet)) ( Fn Button Assigned with )įor the USB connection cable, use one that is a shielded product with a ferrite core compliant to USB Type C (USB3.1) that is less than 1.5 m (4.9 feet).įor the cable that connects to the LAN terminal, use the one below. You can also perform the same operation by pressing the Fn button assigned with. To terminate the network connection between the camera and PC, follow the steps below. (from 8 to 31 characters)Ī tether icon is displayed in the upper right of the screen during recording standby. Set a password to connect to the camera from “LUMIX Tether”. (When connecting for the first time with a LAN cable or Wi-Fi) When using PoE+ power supply with the camera, connect a PoE+ compatible switching hub and PC with a LAN cable.ģUse “LUMIX Tether” to operate the camera from the PC. By connecting the camera directly to your PC with a LAN cable, you can connect the camera to your PC without manually setting network information such as the IP address. ( Wi-Fi Connections)ĢConnect the camera and PC with the USB connection cable or LAN cable.Īt default setting, the camera is set to DHCP server. Set the camera to a Wi-Fi connection setting.
![panasonic lumix app on pc panasonic lumix app on pc](https://www.alphr.com/wp-content/uploads/2014/11/it_photo_166357.jpg)
If you changed the setting of, turn the camera off and then on again. Set the camera to DHCP server before setting it to a wired LAN connection setting. This may cause a malfunction.ġ(When connecting with a USB connection cable) (Inserting these at an angle may cause deformation or malfunction)ĭo not connect the cable to the wrong terminals. Plug in/out straight holding onto the plug. LAN cable (commercially available) or USB connection cable (commercially available)